022-23892476 / 66394004

R-Type Ring Joint Gasket

R-Type Ring Joint Gasket Manufacturer and Exporter in Mumbai, India.

R-Type Ring Joint Gasket
Download PDF

The R-Type Ring Joint Gasket can be manufactured in two different profiles, oval or octagonal in cross-sections in accordance with API 6a and as Me B16.20, to suits API6B and ASMEB16.50 Flanges. Both types have identical pitch diameter as the flange groove they correspond to. The octagonal type has a higher sealing confident than the oval, therefore being the better gasket of the two. The oval type is the only gasket that will fit with a round bottom groove. Flanges with flat bottom v-grooves will accept either style. These gaskets are designed to seal pressure up to 6250 psi in accordance with as Me B16.50 pressure ratings and up to 5000 psi in accordance with API6a pressure ratings.

EXCEL ring type Joints are manufactured in accordance with the industry standards API 6A, API 17D and ASMEB16.20 or to specific customer requirements. EXCEL produce Ring Type Joints with fully traceable materials and supplied to NACE specifications upon request. ring type Joints manufactured to as Me B16.20, API6a and 17D are permanently marked according to standard requirements.

Protective coating :

In accordance with API Specifications, soft iron and low carbon steel Ring Type Joints are protected with electroplated zinc to a maximum thickness of 13μm. EXCEL can also do the cadmium, Silver and Pea/Xylem coating.

Dimension Tolerances (mm)
API 6A & 17D ASMEB16.20
A - Width ofring ±0.20 ±0.20
B, H - Height of ring ±0.5 +1.3/-0.5
C - Width offlat ±0.20 ±0.20
P - Average pitch diamete ±0.18 ±0.18
23° Angle of sealing face ±0° 30’ ±0° 30’

Surface finish ofthe Style R Ring Type Joint sealing faces (radiuses ends of an Oval and the 23° angled faces of an Octagonalshape) shall not be greater than 1.6µm Ra/ 63 µin RMS. Flexitallic Style R Ring Type Joints can be manufactured in accordance with all relevant standards to suit the following flange designations:

Request a Quote